August 6, 2009 at 2:10 pm
Symptom
You use the multiple selection to call another selection screen. The following problems may occur in this case.
1) On the new selection screen, F4 does not work.
2) When you return, the dialog box for the original multiple selection is not correct.
Other terms
Multiple selection
Reason and Prerequisites
This problem is caused by a program error.
Solution
Implement the attached correction [...]
August 6, 2009 at 2:07 pm
Symptom
In a multiple selection, the system triggers an event in which dynamic selection is used. In the dynamic selection, the system calls the multiple selection again. When you return to the previous multiple selection, it has been destroyed.
Other terms
Multiple selection, dynamic selection
Reason and Prerequisites
This problem is caused by a program error.
Solution
Implement the attached [...]
July 16, 2009 at 10:22 am
Symptom
Restart action is not working in SBTM_TASK_SEL
Other terms
SBTM_TASK_SEL, Task Instance Monitor, Task selection report, Restart action
Reason and Prerequisites
Task selection report retrives the Task BO action properties to decide whether the restart action is allowed or not. Task BO set the restart action properties dynamically based on the automatic task status. In case [...]
July 10, 2009 at 5:43 am
Symptom
You are trying to display/maintain a Maintenance view using SM30 transaction. You get a short dump with error message – ASSIGN_LENGTH_0 in the program SAPLSVIX.
NOTE: This error occurs only if you have maintained a selection condition in the DDIC definition of the view, where the value specified for a field(s) is ”.
Other terms
SM30, [...]
July 10, 2009 at 5:40 am
Symptom
Detailed Component of POWL visible even with no lead selection.
Other terms
POWL, Lead Selection, Detailed component
Reason and Prerequisites
This is a program error
Solution
Please implement the correction instructions.
July 8, 2009 at 9:18 pm
Symptom
You have a maintenance view with some Selection Conditions pre-defined. These selection conditions are defined in ranges (using GT, GE, LE and LT options). The conditions are for non-CHAR fields.
When you goto SM30 to display/maintain the view data, you enter new values for the above selection conditions. You observe some of the following [...]
July 3, 2009 at 8:52 pm
Symptom
You have a maintenance view with some Selection Conditions pre-defined. These selection conditions are defined in ranges (using GT, GE, LE and LT options). The conditions are for non-CHAR fields.
When you goto SM30 to display/maintain the view data, you enter new values for the above selection conditions. You observe some of the following [...]