Basis Errors and Solutions

Changing the sender interface in Integrated Configuration

July 8, 2009 at 9:06 pm

[Configuration] [delphi sender] [Directory] [integrated] [Interface] [object sender] [object sender even] [PI] [Sender] [service] [super email sender] [XI]

Error after changing mail channel configurationSymptom When a mail sender channel with party or service * is modified and the changelist is activated in Integration Directory and if the Adapter Engine on which the channel is running...
Using Soap Sender Channel with two sender agreementsSymptom You are using the SOAP sender channel in your business scenario for message processing. You have also configured two sender agreements for the same channel. You notice that messages are routed...
Endless save prompts in Configuration ScenarioSymptom You have modified a Configuration Scenario and started the Model Configurator for the scenario. When you try to close the scenario, a user prompt asks if the changed Configuration Scenario shall...
Configuration of A2A PCIMs with mappingSymptom An Aris Process Component Interaction Model with two internal Process Components (A2A PCIM) and a connection with an Operation Mapping is transferred to the PI Directory. After configuration of the process...
Web Service Consumer Configuration via WSDL documentSymptom When configuring a Web Service (WS) consumer Logical Port (LP) in the single configuration view of transaction SOAMANAGER, you recognize, that any operation specific property value settings (especially the ’soapAction’ property)...
Transport of parameterized Directory objectsSymptom Interface Determination and enhanced Receiver Determination objects can use parameterized Operation Mappings. If such a mapping performs RFC or JDBC lookups, then a Communication Channel is assigned to the parameters in...

Symptom

An Integrated Configuration uses a sender Service Interface which exists in the ESR and has interface pattern ’stateless’. An operation specific routing rule is defined for the Integrated Configuration. When the user changes the software component version of the sender interface in the inbound processing tab, then all dependent information must be removed, i.e. routing rule, receiver interfaces and inbound processing. But the routing rule is not adjusted properly to changes of the sender interface, e.g. the operation list is still visible though the software component version of the sender interface was removed.
Other terms

Integrated Configuration, PI, XI Directory, Service Interface, sender interface
Reason and Prerequisites

This problem is caused by a program error.
Solution

Install the latest patch, the correction is available for NW 7.11 SP4, NW 7.20 SP1 and subsequent releases.